Hi,

I'm trying to run CENSO but it fails in part2. I'm using CENSO v1.1.2, ORCA v5.0.0 and xtb v6.4.1

The problem is when the xtb call orca.

       ------------------------------------------------- 
      |                   D R I V E R                   |
      |     running other programs in this program      |
       ------------------------------------------------- 

########################################################################
[ERROR] Program stopped due to fatal error
-2- Setup for calculation failed
-1- extern_orca_checkOrca: Could not locate orca executable
########################################################################
abnormal termination of xtb

But on the other hand, the ORCA single points run well. So what would be the difference in declaring the path when calling ORCA or through xtb

Here files.zip, there are a few of files that I think that could be of interest. (censorc, censo.out, opt2-part2.out, inp, opt.inp, sp.out, these last three files are those of step 2)

Thanks