Have spent several hours with the program again, maybe a good idea:

The small message box to override the speed performance and rapid traverse our laser power.
Can you Move it permanently to the left side.

The Gcode rattles through the textbox so fast anyway, i can not track that.
In addition, most people have larger screens because it will not be a problem.

For this you may need a reset button to reset the parameters, or
a "right click" on the respective controller and he resets to the original value. so you can reset each controller individually.

An example, I have new wood that I would like to engrave.
Set the laser to S1000 (full power) now I can use the laser power regulator to set the needed on the wood during a test,
but when I'm with a mouse for a while somewhere else, the little window is gone again, but then maybe I wanted to vary the speed ....
So I have to click on it again and again.
if it were permanently integrated, that was much faster.

Just an idea from me ...

Greetings and nice weekend,

Xillius

Now:

Future??