First of all, many, many thanks for such a great software !!!

In addition, freeware and in several languages, you have my full respect!

When I run a gcode program,
I can only stop it completely via the "lightning symbol".

While it may stop and continue (with the buttons on the left side), but can not abort.

And when I do it over "Reset Grbl" I lose my home position.

Would it be possible to implement a cancel button?

The second topic, I have my fan (for laser cooling and component) connected via my board, on the Gcodes M08 and M09 I can start and stop this.

With my Gcode files that works fine too.

But if I use the integrated image to laser option,
I have the command (have a button created) always active even before beginning.

Is it possible to add an option so that the M08 / M09 is immediately implemented?

Sometimes I forget to activate the fan before start the gcode program, then I can only reset and lose the home position as described above.

Is it also possible that you write me an email, have a few small Inovation / ideas for the laser plotter, would like to introduce you.

Greetings, Xillius