Not an issue - just a wish. OK - I'm weird - I need less resolution. I'm melting foam. The surface is above focal point so horizontal scan from blue laser diode melts a 1.5mm 'tall' swath. The goal is to get the 100 sq.px image to be 150mm sq. - made with 100 scan lines (and laser intensity adjusted 100 times per line). The Quality value won't go below 1.000 line/mm (I'd like 0.75). My stepper res is 19.685 steps/mm. I could probably fake it out with $100,$101=30, but I might not remember to change it back before quiting for the day (so it doesn't mess up the next thing I do next week) - so I'm wishing for '1 line /1.5mm' to work.
Could it be as simple as 'Remove the '<1' error-check and let the math do it's thing.' ?
OR... is there an alternate setting I'm ignorant of?
BTW - can't wait to make $$ using this so I can DONATE! :-)